Cracks in poured foundations can be repaired with low-pressure injection of an epoxy or polyurethane foam material. For the repair of cracks in concrete floors, there are certain epoxy and polyurea materials that are suitable for such tile repairs. The technician's job is to regulate the flow and pressure of the liquid in the concrete crack for a lasting end result. If water seeps continuously through the crack, it must be stopped for the epoxy injection to produce a proper repair. Roadware 10 Minute Concrete Mender can be injected into concrete to create a rapid gel and cure time.
This material can be combined with fabricated sand to form a PCC-compatible polymer concrete that can structurally repair cracks and chips in concrete. Most homeowners identify concrete cracks in their basement, either in the foundation wall or in the floor. The compression spring of the dispensing tool should be used to push the material into the crack with slow, steady pressure. Epoxy injection that takes several hours to cure will sink to the bottom of the crack and build up in the base before it has a chance to cure. However, the pillars will not seal existing cracks, which may still need to be injected to prevent leakage after the base has stabilized.
Epoxy resins that are labeled as water insensitive during curing can develop milky white bond lines if injected into wet or damp cracks. It is critical to mix two-component materials like epoxy and polyurethane foams used for crack injection in the correct proportions to avoid problems with unreacted polymers. Injection of epoxy resin presents an excellent means of repairing cracks in floors and walls, but it is not designed to seal leaks. Concrete Mender does not need to be forced into cracks with high-pressure pumps and extraordinary methods. Crack injection can be successfully performed in cracks as narrow as 0.013 mm wide with general epoxy injection resins.
It is recommended to seal the crack with a sacrificial epoxy and install injection ports every few centimeters.
